This section applies to a JACE-603 or JACE-645 that has been configured for Niagara R2, using the Install Niagara R2 wizard. When configuring a JACE-603 or JACE-645 for Niagara R2 operation, there are a few additional items you may wish to review (and possibly change), from the Platform Administration view. This is the same platform view you use to access the Install Niagara R2 wizard, change date and time, and update platform credentials in a new unit.
As shown in Figure 17, the Platform Administration view is one of several platform views for any QNX-based JACE platform, listed in its main platform view.
Two buttons in this view do not apply to a Niagara R2 configured JACE-603 or JACE-645, and are dimmed:
-
Set Module Filter — Applies only to a JACE configured for NiagaraAX.
-
Commissioning — A wizard that steps through many related NiagaraAX platform tasks, it also applies only for a JACE configured for NiagaraAX (not Niagara R2).
Exception: If a “clean dist” has been installed in a JACE-603 or JACE-645, you must subsequently use the Commissioning Wizard to install NiagaraAX build 3.6.44 or later—even the final configuration needs to be Niagara R2. For related details see Distribution File Installer.