Run the Commissioning wizard

The Commissioning Wizard provides a checklist for performing essential and often one-time platform tasks to set up a new JACE or upgrade the core NiagaraAX software in an existing JACE.

Before you begin:

Open the JACE platform.
Confirm that you are connected to the internet.

To launch the wizard, right-click the platform in the Nav tree and click Commissioning Wizard.
By default all commissioning steps are selected. For a new JACE you should accept all default selections.
In the Commissioning dialog, click to include or omit steps and click Next .
In the Licensing dialog, accept the default and click Next.
A minimum of one license is required.

The system downloads the appropriate licenses from the licensing server.
To install the module .jar files, accept the default selection on the Module Content Filter Level dialog and click Next.
In the Station Installation dialog, if you have a specific database on your PC with stations that are ready to install, select the Station from the drop-down list, fill in a New Name for the station, select the option for when to start the station, and click Next.
In the next Station Installation dialog, select which station files to copy.
Copy only the “config.bog” station database file copies only the station configuration (components), and not any supporting folders/files, such as px files, html files, and so forth.
In the Software Installation dialog, click the selection box next to the module name to select additional software modules that are required for your installation and click Next.
Before this dialog appears, a popup “Rebuilding software list” briefly appears as the dependencies of the JACE are compared against the available software modules in your Workbench PC’s software database.

Note

Do not select modules unless you are sure that they are needed. You can manage software modules later using the Software Manager.
In the Distribution File Installation dialog, click Next.
This dialog lists dependent files for the JACE platform that need to be installed.
Make selections on the each of the next three dialogs and click Next for each.
- The TCP/IP Configuration dialog configures TCP/IP settings.
  
  Note
  
  Appropriate DNS and Gateway IP addresses must be set to permit connection with the DRAS server. Otherwise, the AdrDevices will not be able to establish communication with the external server.
- The Platform Daemon Authentication dialog defines platform credentials.
- The Lexicon Installation dialog selects the language to be used by the JACE.
Review the options you selected.
- Click Back to make changes.
- Click Finish to begin the installation process.
When completed, the wizard reboots the JACE and displays a final dialog. Click Close to complete the process.

For more information about the Commissioning Wizard and the options available to configure a JACE, see the JACE NiagaraAX Install & Startup Guide (module://docJaceStartup/doc/index.html).