Configuring the JciN2Network

Right-click the JciN2Network and select Views > Property Sheet. The JciN2Network property sheet appears. You can also use the View Selector to display the Property Sheet.

In the Property sheet, expand the Serial Port Config. For a new FX Supervisory Controller, the status displays {fault} and the Fault Cause displays No port selected for serial communication.

In the Port Name field, change the entry from none to the actual COM port assignment for the desired physical RS-485 trunk on the FX Supervisory Controller. Refer to the FX Supervisory Controller’s installation instructions for the COM port assignment for the desired RS-485 serial port.

Click Save. The Status changes from {fault} to {ok}, and the Fault Cause changes to blank.