This lower area of the Niagara Network Job Builder lists all the stations to be processed by the job—note this means each station processes all steps in the (middle pane) Steps for each station List. Only stations in the Supervisor’s NiagaraNetwork can be added. For any job, you add one or more stations, and you can also remove and reorder stations (stations are processed in a top-to-bottom order).
Add a station to a job in the Niagara Network Job Builder by doing any of the following:
-
Click the “” (add) button below the list, and choose the station(s) in the Add Device popup dialog (see Figure 4 and Figure 5). A button allows you to choose all stations.
-
Right-click in the Stations List, select Add, and choose the station(s) in the same popup dialog.
-
From the Nav tree, simply drag a station from under the NiagaraNetwork into the Stations List.
Note the dialog for adding stations also reflects any station folders (
NiagaraStationFolder) in an expandable tree structure. Also, stations are listed using any assigned “display names” (Figure 5).
This station tree structure using station display names (if assigned) can be useful on Supervisors that have very large numbers
of subordinate JACE stations. Click on controls to expand 
and collapse 
station folders, as needed. A selected 
folder 
will select all nodes under it (stations and any subfolders).
Remove a station from a job in the Niagara Network Job Builder using either of these two methods:
-
Click to select the station, then click the “” (remove) button below the list.
-
Right-click the station, then select from the popup menu.
Reorder a selected station in the Niagara Network Job Builder by clicking the (up) or (down) arrow button at the bottom of the list. Or, right-click a station and select or , as needed.
Stations are processed in the same top-to-bottom order as defined in the Stations List.