The copier works in either direction. In other words, click a station on one side (to copy to the other side). When you click a station, the station is selected (highlighted) and the appropriate button, by direction, becomes enabled to clarify the source and target. See Figure 79.
In AX-3.7u1, in some cases a copy local-to-remote (install) may first require offline editing of the saved config.bog file,
or alternatively some subsequent password editing after the install. (Note this does not apply if the station’s host is running
AX-3.8.) See Security update 1 changes to Station Copier usage for more details.
To perform the following station operations, you:
-
Click in left side for a copy from local-to-remote.
Do this to install a station in a JACE. This is called “installing” in remaining document subsections.
-
Click in right side for a copy from remote-to-local.
Do this to make a local backup copy of a station, saved to your Workbench computer. This is described as a “backup” in the following document subsections.
When you click a button, a wizard guides you the rest of the way.
Dependency checks may prevent the installation of a selected station—where the Station Transfer Wizard does not start. See
the next section Station Copier dependencies check for more details.