WebService settings for platform tunneling

In the Supervisor’s WebService (under Config, Services), ensure that the two properties below are as shown in Figure C.2.

Figure C.2. WebService in Supervisor to support platform tunneling

Tunneling Enabled

Set to true. If Fox and HTTP tunneling are already enabled, this should already be enabled.
Proxy Authentication When Tunneling

Set to false. In the initial AX-3.5 implementation of platform tunneling, proxy authentication is not supported. The only login authentication used in a tunneled platform connection are the tunnel endpoint’s (JACE’s) platform credentials.
This property was first introduced in AX-3.4, and for an existing job upgraded from AX-3.4 to AX-3.5 may be true. To permit platform tunneling, you must set it to false.